Device maintenance and repair
7.4 Installing operating system, software and drivers
SIMATIC IPC627E
Operating Instructions, 12/2018, A5E44297201-AA
107
7.4 Installing operating system, software and drivers
7.4.1 Installing the operating system
Information on restoring or reinstalling the operating system you ordered with the device can
be found in the detailed operating system description, see "Important instructions and
manuals for operating the device (Page 11)".
7.4.2 Installing software and drivers
On the supplied USB stick (read only), you will find the "Documentation and Drivers" suite,
which you use to install all supplied software and drivers.
Procedure
1. Connect the supplied USB flash drive.
2. Start the "Documentation and Drivers" suite from the USB stick by running the file
"START_DoucAndDrivers.CMD".
3. Install the desired software and drivers.
7.5 Configuring firmware/BIOS
You can find information on configuring firmware/BIOS and on the firmware settings in the
delivery state in the "Firmware/BIOS description
(https://support.industry.siemens.com/cs/ww/en/view/109760621)".
Note
If your IPC fails to boot, for example, by crashing during a BIOS update, conta
ct your local
You can find information on "BIOS Recovery" and "ME update" under "Pin assignment of the
internal interfaces (Page 137)".
7.6 Backing up data and changing partitions
We recommend the "SIMATIC IPC Image & Partition Creator" software to back up data
under Windows®, which supports the hardware of the device as of version 3.5.3.
You will find detailed information on this software in: "SIMATIC IPC Image & Partition
Creator (https://support.industry.siemens.com/cs/ww/de/view/21766418/en)".
Please also observe the information in "Technical specifications of the operating systems
(Page 119)".
To Next Page
Loading...
Need help?
General
