Siemens SIMATIC IPC627E

Expanding and assigning parameters to the device
6.4 Drives
SIMATIC IPC627E
Operating Instructions, 12/2018, A5E44297201-AA
81
6.4.2 Changing internal SSD
Requirements
● The device is disconnected from the mains and all connecting cables have been
removed.
● The device is open, see important information regarding this under Opening the Device
(Page 71).
● An original spare part, that is an SSD of the same type, see information under
Accessories: Hardware (Page 24).
Procedure - Removal
1. Remove the marked screws.
2. Remove the marked screws and place the SSD on its side.