Siemens SIMATIC S7 - Inserting a Memory Card in a Standard CPU

PLC concepts
4.3 Saving and restoring data
S7-200 SMART
96 System Manual, V2.3, 07/2017, A5E03822230-AF
4.3.5
Inserting a memory card in a standard CPU
Table 4- 24 Inserting and removing a memory card in a standard CPU
Task
Procedure
Follow the steps below to insert the microSDHC
memory card into the CPU.
1. Open the bottom terminal block connector
cover.
2. Insert the microSDHC memory card in the
memory card slot (marked X50) located
above the terminal block connectors.
3. Replace the terminal block connector cover
after inserting the card to ensure that the card
is secure.
Follow the steps below to remove the mi-
croSDHC memory card from the CPU.
1. Open the bottom terminal block connector
cover.
2. Grasp the microSDHC memory card from the
CPU and pull it out of the card slot (marked
Micro-SD X50).
3. Replace the bottom terminal block cover.