Siemens SIMATIC S7 - Configuring the BA01 Battery Signal Board

PLC device configuration
6.1 Configuring the operation of the PLC system
S7-200 SMART
System Manual, V2.3, 07/2017, A5E03822230-AF
163
Baud rate
Choose the desired data baud rate from the dropdown list:
● 9.6 Kbps
● 19.2 Kbps
● 187.5 Kbps
6.1.15
Configuring the BA01 battery signal board
Click the BA01 battery signal board node of the system block (Page 133) dialog to configure
options for a BA01 battery signal board that you have selected in the top section.
Note
The CPU models CPU CR20s, CPU CR30s, CPU CR40s, and CPU CR60s do not support
the use of expansion modules or signal boards.
Enable bad diagnostic alarm
Click the “Enable bad diagnostic alarm” checkbox to trigger an alarm when the battery fails.
Enable status in digital input
Click the "Enable status in digital input" to enable a digital input to monitor the status of the
signal board.