Siemens SIMOCODE pro PCS 7

Parameter
A.5 Block parameter MMStat
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
263
Parameter
Data format
Default setting
Meaning
RdWrAct STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Operator enabled for read / write record
LocalAct STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Motor in Local Operation Mode: Local Mode Indi-
cator
OnAct STRUCT
• Value: BOOL
• ST: BYTE
–
• 1
• 16#80
On Mode is active
OosAct STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Out of service is active
P_StrtAct STRUCT
• Value: DINT
• ST: BYTE
–
• 0.0
• 16#80
Permissible Starts-Actual Value
TmTstReq STRUCT
• Value: REAL
• ST: BYTE
–
• 0.0
• 16#80
Time Until test required in week
N_Param STRUCT
• Value: DINT
• ST: BYTE
–
• 0.0
• 16#80
Number of parameterization
N_OvlTrp STRUCT
• Value: DINT
• ST: BYTE
–
• 0.0
• 16#80
Number of overload trips
N_IntOvlTrp STRUCT
• Value: DINT
• ST: BYTE
–
• 0.0
• 16#80
Number of internal Overload trips
M_StpTm STRUCT
• Value: DINT
• ST: BYTE
–
• 0.0
• 16#80
Motor Stop Time in hour
Tmr1Act STRUCT
• Value: REAL
• ST: BYTE
–
• 0.0
• 16#80
Tmr1Act Actual Value in sec
Tmr2Act STRUCT
• Value: REAL
• ST: BYTE
–
• 0.0
• 16#80
Tmr2Act Actual Value in sec