Siemens SIMOCODE pro PCS 7

Parameter
A.7 Block parameter MMRevDhl
SIMOCODE pro PCS 7 Library V9.0
280 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Parameter
Data format
Default setting
Meaning
R_StpAct STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Rapid stop is active
LockAct STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Interlock (Permit, Interlock or Protect) or Trip is active
GrpErr STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Group error is active
RdyToStart STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Ready to start
RdyToReset STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Ready to reset via RstLi or automatic commands
WarnAct STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Warning Prior to Motor Start in Auto/Manual Mode
FFwd STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Control Output to Start Fast Forward
Fwd STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Control Output to Start Motor Forward
Rev STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Control Output to Start Motor Reverse
FRev STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Control Output to Start Fast Reverse
P_FFwd STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Pulsive Control Output to Start Motor Forward
P_Fwd STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Pulsive Control Output to Start Motor Forward