Siemens SIMOTICS M-1PH8 - Page 16

• Counterspindles or power tools for turning machines
• Direct power tools with internal cooling
• Main drives in presses and extruders, converting applications
• Rotary axes in the paper and printing industry
• For use in crane systems (power house)
• Flying shears, coilers and winder drives
• Customized machines
WARNING
Danger to life and material damage when incorrectly used
If you do not use the motors or their components correctly, there is a risk of death, severe injury
and/or material damage.
• Only use the motors for industrial or commercial plants and systems.
• If, in an exceptional case, you do not use the motors in industrial or commercial plants and
systems, ensure that increased requirements are complied with (e.g. regarding touch
protection).
• Do not use the motors in hazardous areas (where there is a risk of explosion), if the motors
have not been expressly released and authorized for these types of applications. Comply
with the separately added supplementary notes.
• Only use the motors and their components for the applications speci󹪝ed by Siemens.
• Protect the motors against dirt and contact with aggressive substances.
• Ensure that the site conditions comply with the rating plate data and the conditions
speci󹪝ed in this documentation. Take into consideration deviations regarding approvals or
country-speci󹪝c regulations.
• If you have any questions regarding the intended use, please contact your local sales
partner.
• If you wish to use special versions and design variants, whose technical data di󹪜er from the
motors described in this document, then 󹪝rst contact your local sales partner.
WARNING
Danger to life for wearers of active implants due to magnetic and electrical 󹪝elds
Persons with active implants, for example cardiac pacemakers, standing close to the motors
can be negatively a󹪜ected, which could cause serious damage to their health or even death.
• If you are a󹪜ected, stay at a minimum distance of 500mm from the motors (tripping
threshold for static magnetic 󹪝elds of 0.5 mT according to the Directive 2013/35/EU).
The motors are designed for operation in covered areas under normal climatic conditions, such
as those found in production environments.
Introduction
1.6Important product information
1PH8 SIMOTICS M main motors
14 Con󹪝guration Manual, 12/2022, A5E51895839A