Siemens SINAMICS V10 - Page 32

Mounting the operator panel to cabinet door
Proceed the following procedure to mount the operator panel to cabinet door:
1
2
3
4
4 x M3 mounting screws
and washers
(Tightening torque: 0.8 Nm)
Front view
Cabient door
Door cut-out
Rear view
$SSO\DGRZQZDUGSUHVVXUHWRWKH
ODWFKRQWKHRSHUDWRUSDQHO
'HWDFKWKHWRSRIWKHRSHUDWRUSDQHOIURP
WKHLQYHUWHUERG\XQLW
5HPRYHWKHRSHUDWRUSDQHOIURPWKH
LQYHUWHUERG\XQLW
0RXQWWKHRSHUDWRUSDQHOWRFDELQHWGRRU
,QWHUIDFHIRUFRQQHFWLQJ
WKHRSHUDWRUSDQHOZLWK
LQYHUWHUERG\XQLW
Figure 5-11 Procedure for mounting the operator panel to cabinet door
Note
For the cable connection between the operator panel and the inverter body unit, see topic
"Interface definition (Page 33)".
Installation
5.1 Mechanical installation
SINAMICS V10
32 Operating Instructions, 08/2011, A5E03453178 (this is not an order number)