NOTICE
To change the default lamp ON setting as indicated in figures below, go to P0748.
To calibrate the analog input setpoint in some typical connection modes mentioned below,
go to P0753 to P0761.
To calibrate the analog output setpoint in some typical connection modes mentioned below,
go to P0771 to P0781.
In addition to application macros, for each typical connection mode (except "Typical
connection mode 1") as described below, still you can set some read-only or unlocked
parameters as per your particular demands.
Some default parameter values depend on specific connection macro, inverter type, motor
rating data, etc. You can find detailed description of these parameters in Chapter 7 Parameter
List.
Function of DC Braking can be enabled through proper settings of P0703 and P1230.
In LOC mode, default frequency setpoint depends on P1040. For relative parameters, please
refer to P1031 and P1040.
For parameters related to connection modes, please see table in Application macros
(Page 56).
Commissioning
6.1 Typical connection modes
SINAMICS V10
40 Operating Instructions, 08/2011, A5E03453178 (this is not an order number)
To Next Page
Loading...
