Siemens SINAMICS V10 - Page 90

Par. No. Name Range Default Unit
r0947[8] Last fault code -- -- --
Displays fault history according to the diagram below:
U>@
&XUUHQWIDXOWKLVWRU\
0RVWUHFHQWDQGDOUHDG\DFNQRZOHGJHGIDXOWVLQಯ&XUUHQWIDXOWKLVRWU\ಯ
1RDFWLYHIDXOWIRU
DFNQRZOHGJHPHQW
1RDFWLYHIDXOWIRU
DFNQRZOHGJHPHQW
VWDFWLYHIDXOWQRW\HWDFNQRZOHGJHG
)DXOWFRGHVDOUHDG\
UHPRYHGIURPWKHKLVWRU\
U>@
U>@
U>@
U>@
U>@
U>@
U>@
)
)


)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
1HZIDXOWKLVWRU\8SGDWHGIDXOWKLVWRU\




0RVWUHFHQWDQGDOUHDG\DFNQRZOHGJHGIDXOWVLQಯ1HZIDXOWKLVWRU\ಯ




QGDFWLYHIDXOWQRW\HWDFNQRZOHGJHG




0RVWUHFHQWDQGDOUHDG\DFNQRZOHGJHGIDXOWVLQಯ8SGDWHGIDXOWKLVWRU\ಯ
Where:
Acknowledging the active faults will moves the value in the 2 indicates down to the next pair of indicates,
where they are stored. Indicates 0 & 1contain the active faults. When faults are acknowledged, indicates 0 &
1 are reset to 0.
Index:
r0947[0]: Recent fault trip - -, fault 1
r0947[1]: Recent fault trip - -, fault 2
r0947[2] Recent fault trip - 1, fault 3
r0947[3] Recent fault trip - 1, fault 4
r0947[4]: Recent fault trip - 2, fault 5
r0947[5]: Recent fault trip - 2, fault 6
r0947[6] Recent fault trip - 3, fault 7
r0947[7] Recent fault trip - 3, fault 8
Dependency:
Index 1 used only if second fault occurs before first fault is acknowledged.
Parameter list
SINAMICS V10
90 Operating Instructions, 08/2011, A5E03453178 (this is not an order number)