Siemens SINUMERIK 808D User Manual

Programming and Operating Manual (Milling)
254 6FC5398-4DP10-0BA6, 09/2017
Enter the desired parameters as follows:
7.
Press this softkey to confirm your input and open the cycle programming window.
Continue to enter the following program block:
S2500 M3
8.
Press this softkey to return to the program editor window.
9.
Move the cursor to "C" in the line for CYCLE71 with the curs
or keys and press this softkey
to insert a marker.
10.
Use the cursor keys to select the entire program block for CYCLE71. Press this softkey to
copy the selection to the buffer memory.
11.
Place the cursor in the last empty line and press this softkey to paste the content of the
buffer memory into the empty line.
12.
Press this softkey to open the window for CYCLE71 again. Change the values of "FALD"
and "FF
P1" to "0" and "400" respectively.
13.
Move the cursor to the input field of "VARI" and press this key to change the value to "32".
14.
Press this softkey to accept the change.

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English