Siemens SINUMERIK 808D - Page 262

Programming and Operating Manual (Milling)
262 6FC5398-4DP10-0BA6, 09/2017
Screen 7:
Operating sequence for programming in ISO mode
+
1. Select the system data operating area.
2. Press this softkey and the system prompts the following window:
3. Press this softkey and control system automatically starts the mode change from Sie-
mens mode to ISO mode.
4.
Select the program management operating area.
5. Press this softkey to enter the system directory for storing part programs.
6.
Press this softkey and enter the name of the new program.
7. Press this softkey to confirm your entry. The part program editor window opens automati-
cally.