Siemens SINUMERIK 808D - Page 268

Programming and Operating Manual (Milling)
268 6FC5398-4DP10-0BA6, 09/2017
Operating sequence for programming in Siemens mode
1.
Select the program management operating area.
2.
Press this softkey to enter the system directory for storing part programs.
3.
Press this softkey and enter the name of the new program.
4.
Press this softkey to confirm your entry. The part program editor window opens automatical-
ly.
5.
Enter the following pro
gram in the window. The control system saves your editing automati-
cally.
6.
Open the window for CYCLE71 through the following softkey operations:
→