Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
269
Enter the desired parameters as follows:
7.
Press this softkey to confirm your input and open the cycle programming window.
Continue to enter the followi
ng program block:
8.
return to the program editor window.
9.
Move the cursor to "C" in the line for CYCLE71 with the cursor keys and press this softkey
to insert a marker.
10.
Use the cursor keys to select the entire program block for CYCLE71. Press this softkey to
copy the selection to the buffer memory.
Place the cursor in the last empty line and press this softkey to paste the content of the
buffer memory into the empty li
ne.
12.
Press this softkey to open the window for CY
CLE71 again. Change the values of "FALD"
and "FFP1" to "0" and "400" respectively.
13.
Move the cursor to the input field of "VARI" and press this key to change the value to "32".
14.
Press this softkey to accept the change.
15.
Continue to enter the following program blocks and then press this key again:
Open the window for CYCLE76 through the following softkey operations:
To Next Page
Loading...
Need help?
General
