Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
329
ROT Rotation, programmable
ROT RPL=... ; rotation in the
current plane G17 to G19,
separate block
SCALE Programmable scaling factor SCALE X... Y... Z... ; scaling
factor in the direction of the
specified axis, separate block
MIRROR Programmable mirroring MIRROR X0; coordinate axis
whose direction is changed,
separate block
Additive translation, programming
ATRANS X... Y... Z... ; sepa-
rate block
AROT Additive programmable rotation AROT RPL=... ; rotation in the
current plane G17 to G19,
separate block
ASCALE Additive programmable scaling factor ASCALE X... Y... Z...; scaling
factor in the direction of the
specified axis, separate block
AMIRROR Additive programmable mirroring AMIRROR X0 ; coordinate
axis whose direction is
changed, separate block
G110 Pole specification relative to the last pro-
grammed setpoint position
G110 X... Y... ; Pole specifica-
tion, Cartesian, e.g.: for G17
G110 RP=... AP=... ; Pole
specification, polar, separate
block
G111 Pole specification relative to origin of cur-
rent workpiece coordinate system
G111 X... Y... ; Pole specifica-
tion, Cartesian, e.g.: for G17
G111 RP=... AP=... ; Pole
specification, polar, separate
G112 Pole specification, relative to the last valid
POLE
G112 X... Y... ; Pole specifica-
tion, Cartesian, e.g.: for G17
G112 RP=... AP=... ; Pole
specification, polar, separate
block
G17 * X/Y plane 6: Plane selection, modally
effective
G17 .... ; Vertical axis on this
plane is tool length
G18 Z/X plane
G40 * Tool radius compensation OFF 7: Tool radius compensation,
modally effective
G41 Tool radius compensation left of contour
Tool radius compensation right of contour
G500 * Settable work offset OFF 8: Settable work offset, modal-
ly effective
G57 4. Settable work offset
G53 Non-modal skipping of the settable work
9: Suppression of settable
To Next Page
Loading...
Need help?
General
