Siemens SINUMERIK 808D User Manual

Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017
331
Address
Significance
Value assignments
Information
Programming
J
Interpolation param-
eters
±0.001 ... 99
999.999
Thread:
0.001 ... 2000.000
Belongs to the Y axis; other-
wise, as with I
See G2, G3, G33, G331, and
G332
K
Interpolation param-
eters
±0.001 ... 99
999.999
Thread:
0.001 ... 2000.000
Belongs to the Z axis; other-
wise, as with I
See G2, G3, G33, G331, and
G332
I1=
Intermediate point
for circular interpola-
tion
±0.001 ... 99
999.999
Belongs to the X axis; specifi-
cation for circular interpolation
with CIP
See CIP
J1=
Intermediate point
for circular interpola-
tion
±0.001 ... 99
999.999
Belongs to the Y axis; specifi-
cation for circular interpolation
with CIP
See CIP
K1=
Intermediate point
for circular interpola-
tion
±0.001 ... 99
999.999
Belongs to the Z axis; specifi-
cation for circular interpolation
with CIP
See CIP
L
Subroutine; name
and call
7 decimals;
integer only, no sign
Instead of a free name, it is
also possible to select L1
...L9999999;
this also calls the subroutine
(UP) in a separate block.
Please note: L0001 is not
always equal to L1.
The name "LL6" is reserved
for the tool change subroutine.
L781; separate block
M
Additional function
0 ... 99
only integer, no sign
For example, for initiating
switching actions, such as
"coolant ON", maximum five M
functions per block.
M...
M0
Programmed stop
The machining is stopped at
the end of a block containing
M0; to continue, press the
following key:
M1 Optional stop As with M0, but the stop is
only performed if a special
signal (Program control:
"M01") is present.
M2
End of main program with return to begin-
ning of program
Can be found in the last block
of the processing sequence
M30
End of program (as M2)
Can be found in the last block
of the processing sequence
M17
End of subroutine
Can be found in the last block
of the processing sequence
M3
CW rotation of spindle
M4
CCW rotation of spindle
M5
Spindle stop
M6
Tool change
Only if activated with M6 via
the machine control panel;
otherwise, change directly
using the T command
M40
Automatic gear stage changeover

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English