Siemens SINUMERIK 808D User Manual

Programming and Operating Manual (Milling)
338 6FC5398-4DP10-0BA6, 09/2017
Address
Significance
Value assignments
Information
Programming
SET( , , , )
REP()
Set values for the
variable fields
SET: Various values, from the
specified element up to: ac-
cording to the number of val-
ues
REP: the same value, from the
specified element up to the
end of the field
DEF REAL
VAR2[12]=REP(4.5) ; all ele-
ments value 4.5
N10 R10=SET(1.1,2.3,4.4) ;
R10=1.1, R11=2.3, R4=4.4
SF
Thread starting point
when using G33
0.001 ... 359.999
Specified in degrees; the
thread starting point with G33
will be offset by the specified
value (not applicable for tap-
ping)
See G33
SPI(n)
Converts the spindle
number n into the
axis identifier
n =1,
axis identifier: e.g. "SP1" or
"C"
SPOS
Spindle position
0.0000 ... 359.9999
with incremental
specification (IC):
±0.001 ... 99
999.999
Specified in degrees; the
spindle stops at the specified
position (to achieve this, the
spindle must provide the ap-
propriate technical prerequi-
sites: position control
N10 SPOS=....
N10 SPOS=ACP(...)
N10 SPOS=ACN(...)
N10 SPOS=IC(...)
N10 SPOS=DC(...)
STOPFIFO
Stops the fast ma-
chining step
-
Special function; filling of the
buffer memory until
STARTFIFO, "Buffer memory
full" or "End of program" is
detected.
STOPFIFO; separate block,
start of filling
N10 X...
N20 X...
STARTFIFO
Start of fast machin-
ing step
-
Special function; the buffer
memory is filled at the same
time.
N30 X...
STARTFIFO ;separate block,
end of filling
STOPRE
Preprocessing stop
-
Special function; the next
block is only decoded if the
block before STOPRE is com-
pleted.
STOPRE ; separate block
TURN
Number of additional
circle passes with
helix interpolation
0 ... 999
In conjunction with circular
interpolation G2/G3 in a plane
G17 to G19 and infeed motion
of the axis vertical to this
plane
N10 G0 G17 X20 Y5 Z3
N20 G1 Z-5 F50
N30 G3 X20 Y5 Z-20 I0 J7.5
TURN=2; total of three full
circles
TRACYL
Milling of the periph-
eral surface
Kinematic transformation
(available only if configured
accordingly)
TRACYL(20.4); Separate
block; Cylinder diameter: 20.4
mm
TRACYL(20.4,1) ; also possi-
ble
TRAFOOF
Disable TRACYL
Disables kinematic transfor-
mation
TRAFOOF ; separate block
TRAILON
Coupled motion ON
Activates and defines a cou-
pled axis group
TRAILON(W,X,1) ; separate
block; coupled-motion axis: W,
leading axis: X, coupling fac-
tor: 1
TRAILOF
Coupled motion OFF
Deactivates a coupled axis
group
TRAILOF(W,X) ; separate
block

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English