I
Appendix 10.04
Index
I
ï›™ Siemens AG, 2004. All rights reserved
I-462 SINUMERIK 840D/840Di/810D Operating/Programming ShopMill (BAS) – 10.04 Edition
Residual material 3-217
Roughing 3-216
Contour transition element 3-194
Coolant 2-150, 3-313
Coordinate system 1-23
Coordinate transformation 2-161
Defining 3-302
Corner point 3-176
Count 2-152
Cutter radius compensation 3-172
Cutting edge 3-185
Cutting rate 3-172, 3-185
Cycle viii
Cycle approach 3-180
Cycle support 4-318
Cylinder surface transformation 3-193, 3-305
D
D 3-185
Deep-hole drilling 3-233
Default settings
Changing 2-113
Dialog line 1-35
Dialog selection
Changing 3-199
Direction of spindle rotation 3-313
Directory
Copying 6-358, 6-377
Creating 6-356, 6-375
Deleting 6-359, 6-379
Moving 6-378
Opening 6-351, 6-368
Renaming 6-359, 6-378
Selecting 6-351, 6-368
Disabling a magazine location 2-155
DR 3-186
DRF offset 2-126
Drill 2-137, 2-138
Drill and thread milling 3-242
Drilling 3-230, 3-232
Duplo number 2-139
E
E_COUNTER 3-314
Emergency stop 1-29
End 4-326
Engraving 3-286
Equidistant path 2-149
Error log 6-363, 6-382
Example
Cylinder surface transformation 9-429
Face milling 3-265
Freely defined contours 3-200
Position pattern milling 3-284
Rectagular pocket 3-269
Slot side compensation 9-433
Swiveling 3-311, 9-437
Thread milling 3-241
Examples 9-418, 9-426
Execution 2-115
External thread 3-239
F
Face milling 2-110, 3-216
Feed 3-179
Feedrate 3-173
Feedrate override 1-31
Feedrate status 1-36
Finding an empty location 2-157, 2-159
Fine offset 2-162
Finishing 2-100, 2-101, 3-180
Fixed point
Calibration 2-95
Floppy disk drive 6-355, 6-373
FOR 3-314
G
G code
Copying 4-324
Cutting 4-324
Finding 4-325
Inserting into ShopMill program 3-314
Pasting 4-324
Selecting 4-324
Skipping 2-126
G code block
Renumbering 4-326
G code editor 4-323
G code program
Creating 4-318
Execution 6-355, 6-373
Running 4-321
Simulating 4-321
G function 2-116
Gear stage 3-313
Geometry program 7-386
H
H function 2-116
To Next Page
Loading...
Need help?
General
