Siemens SINUMERIK Series User Manual

$
<
=
Figure 10-1 Y axis is centered above the cylinder
=
<
$
˂<
Figure 10-2 Y axis is not centered above the cylinder
XYA plane
You program in XYA if the Y axis should also move during machining. A value can be specified
for each position.
In addition to the possibilities of XA, the following is also possible, for example.
Programming technological functions (cycles)
10.1 Drilling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 409

Siemens SINUMERIK Series Specifications

General

Axes Control	Up to 31 axes
Category	Control Unit
Manufacturer	Siemens
Series	SINUMERIK
Control Type	CNC
Communication Interfaces	Ethernet, USB
Operating Temperature	0°C to 45°C
Protection Class	IP20
Power Supply	24V DC
Display	Color TFT LCD