Siemens SITRANS F

To Next Page

To Previous Page

z Press the <Right> arrow. Note that the cursor changes to a block that appears after a

question mark (?). This indicates that you have accessed the first character position of an

eight-character (maximum) alphanumeric entry field.

z You can create a site name (up to 8 characters) by scrolling through the list of available

characters, using the <UP> or <Down> arrows or numeric keypad. Pressing the <Right>

arrow advances the cursor to the next character space.

z Once the desired site name is filled in, press the <ENT> key to register the selection.

z Press the <Left> arrow to exit this menu.

Recall Site Setup No Sites

Siemens Site [1]

Right Arrow & Enter Creates a new Site

Channel Enable No

Create/Name Site ?

 



Site Security Off

Delete Site Security No Sites

Save/Rename Site

Channel Setup

This block cursor is

currently placed at the first

character position.

Creating a New Site Setup (See also paragraph 2.1.3 in 1010P Field Manual)

This section provides an example of how to use the [Create/Rename Site] command to create a

new site setup. Always begin a new installation by issuing the [Create/Name Site] command.

Although you do not need to enter a site name to create a new site setup, you will have to provide

one to save the site setup or to identify the source of logged data. In this example, [SITE1] will be

used for the site name.

z To access the [Channel Setup] menu press the <Right> arrow, then move the highlight

down to [Create/Name Site].