Siemens SITRANS FC330 - Page 112

Three values
2
4
6
1
3
)&66
5
① First process value The user-defined process value to be displayed is configured in menu
2 "Setup" → 2.8 "Local display" → 2.8.5 ... 2.8.10 "View" (1-6).
② Lower Alarm Limit The lower limit of the bar graph is defined by the lower alarm limit of the
selected process value (e.g. menu 2.2.1 ... 2.2.6 for mass flow).
③ Upper Alarm Limit The upper limit of the bar graph is defined by the upper alarm limit of the
selected process value (e.g. menu 2.2.1 ... 2.2.6 for mass flow).
④ Bargraph Shows the first process value in relation to its configured maximum and
minimum limits (Upper Alarm Limit and Lower Alarm Limitfor the se‐
lected process value).
⑤ Second process value The user-defined process value to be displayed is configured in menu
2 "Setup" → 2.8 "Local display" → 2.8.5 ... 2.8.10 "View" (1-6).
⑥ Third process value The user-defined process value to be displayed is configured in menu
2 "Setup" → 2.8 "Local display" → 2.8.5 ... 2.8.10 "View" (1-6).
Note
Bargraph
The bargraph limits are defined as the lower and upper alarm values.
One value and bargraph
2
4
1
3
)&66
① Process value The user-defined process value to be displayed is configured in menu 2
"Setup" → 2.8 "Local Display" → 2.8.5 ... 2.8.10 "View" (1-6).
② Lower Alarm Limit The lower limit of the bar graph is defined by the lower alarm limit of the
selected process value (e.g. menu 2.2.1 ... 2.2.6 for mass flow).
③ Upper Alarm Limit The upper limit of the bar graph is defined by the upper alarm limit of the
selected process value (e.g. menu 2.2.1 ... 2.2.6 for mass flow).
④ Bargraph Shows "1st Process value" in relation to its configured maximum and
minimum limits (Upper Alarm LimitandLower Alarm Limitfor the selected
process value).
Operating
7.1 Local operation (HMI)
SITRANS FC330
112 Operating Instructions, 01/2019, A5E44030648-AB