Siemens SITRANS FC330 - Page 178

ID Icons Message Cause/Action
111 Medium temperature be‐
low alarm limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
112 Fraction A % above alarm
limit
Check process conditions. Adjust the parameter value 'Up‐
per alarm limit' to normal process conditions.
113 Fraction A % above warn‐
ing limit
Check process conditions. Adjust the parameter value 'Up‐
per warning limit' to normal process conditions.
114 Fraction A % below warn‐
ing limit
Check process conditions. Adjust the parameter value
'Lower warning limit' to normal process conditions.
115 Fraction A % below alarm
limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
116 Fraction B % above alarm
limit
Check process conditions. Adjust the parameter value 'Up‐
per alarm limit' to normal process conditions.
117 Fraction B % above warn‐
ing limit
Check process conditions. Adjust the parameter value 'Up‐
per warning limit' to normal process conditions.
118 Fraction B % below warn‐
ing limit
Check process conditions. Adjust the parameter value
'Lower warning limit' to normal process conditions.
119 Fraction B % below alarm
limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
Diagnostics and troubleshooting
10.2 Fault codes and corrective actions
SITRANS FC330
178 Operating Instructions, 01/2019, A5E44030648-AB