Siemens SITRANS FC330 - Page 180

ID Icons Message Cause/Action
129 Standard density above
warning limit
Check process conditions. Adjust the parameter value 'Up‐
per warning limit' to normal process conditions.
130 Standard density below
warning limit
Check process conditions. Adjust the parameter value
'Lower warning limit' to normal process conditions.
131 Standard density below
alarm limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
132 Standard volume flow
above alarm limit
Check process conditions. Adjust the parameter value 'Up‐
per alarm limit' to normal process conditions.
133 Standard volume flow
above warning limit
Check process conditions. Adjust the parameter value 'Up‐
per warning limit' to normal process conditions.
134 Standard volume flow be‐
low warning limit
Check process conditions. Adjust the parameter value
'Lower warning limit' to normal process conditions.
135 Standard volume flow be‐
low alarm limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
136 Totalizer 1 above alarm
limit
Check process conditions. Adjust the parameter value 'Up‐
per alarm limit' to normal process conditions.
137 Totalizer 1 above warning
limit
Check process conditions. Adjust the parameter value 'Up‐
per warning limit' to normal process conditions.
Diagnostics and troubleshooting
10.2 Fault codes and corrective actions
SITRANS FC330
180 Operating Instructions, 01/2019, A5E44030648-AB