Siemens SITRANS FC330 - Page 181

ID Icons Message Cause/Action
138 Totalizer 1 below warning
limit
Check process conditions. Adjust the parameter value
'Lower warning limit' to normal process conditions.
139 Totalizer 1 below alarm
limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
140 Totalizer 2 above alarm
limit
Check process conditions. Adjust the parameter value 'Up‐
per alarm limit' to normal process conditions.
141 Totalizer 2 above warning
limit
Check process conditions. Adjust the parameter value 'Up‐
per warning limit' to normal process conditions.
142 Totalizer 2 below warning
limit
Check process conditions. Adjust the parameter value
'Lower warning limit' to normal process conditions.
143 Totalizer 2 below alarm
limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
144 Totalizer 3 above alarm
limit
Check process conditions. Adjust the parameter value 'Up‐
per alarm limit' to normal process conditions.
145 Totalizer 3 above warning
limit
Check process conditions. Adjust the parameter value 'Up‐
per warning limit' to normal process conditions.
146 Totalizer 3 below warning
limit
Check process conditions. Adjust the parameter value
'Lower warning limit' to normal process conditions.
Diagnostics and troubleshooting
10.2 Fault codes and corrective actions
SITRANS FC330
Operating Instructions, 01/2019, A5E44030648-AB 181