Siemens SITRANS FC330 - Page 182

ID Icons Message Cause/Action
147 Totalizer 3 below alarm
limit
Check process conditions. Adjust the parameter value
'Lower alarm limit' to normal process conditions.
148 Transmitter electronics
temperature too high
Decrease the ambient temperature. If possible, reposition
the device in a different location. Inspect the device for
heat-related damages.
149 Transmitter electronics
temperature too low
Increase the ambient temperature. If possible, reposition
the device in a different location. Inspect the device for cold-
related damages.
150 Sensor signal disrupted Turn off the power. Unplug and reconnect the sensor cable.
If the error still exists, contact your local Siemens repre‐
sentative.
151 SensorFlash parameter
backup disabled
A SensorFlash of another device has been inserted. Either
copy the settings from the SensorFlash to the device or
remove this SensorFlash and insert the original Sensor‐
Flash.
152 SensorFlash parameter
backup disabled
A SensorFlash of another device has been inserted. Either
copy the settings from the SensorFlash to the device or
remove this SensorFlash and insert the original Sensor‐
Flash.
153 CH1 loop current in lower
saturation
The process value is so low that the loop current reaches
the lower saturation limit and cannot decrease any further.
Check process conditions. Adjust parameter value 'Lower
range value'.
154 CH1 loop current in upper
saturation
The process value is so high that the loop current reaches
the upper saturation limit and cannot increase any further.
Check process conditions. Adjust parameter value 'Upper
range value'.
155 CH1 loop current error Invalid loop current deviation detected. Check current out‐
put cable connection. Passive operation: check external
power supply.
Diagnostics and troubleshooting
10.2 Fault codes and corrective actions
SITRANS FC330
182 Operating Instructions, 01/2019, A5E44030648-AB