Siemens SITRANS FC330 - Page 186

ID Icons Message Cause/Action
197 CH2 cable break Check current output cable connection. Passive operation:
check external power supply.
198 CH2 output frequency too
low
The process value is below the parameter 'Lower range
value'. The output frequency cannot decrease any further.
Check process conditions. Adjust parameter value 'Lower
range value'.
199 CH2 output frequency too
high
The process value is above the parameter 'Upper range
value'. The output frequency cannot increase any further.
Check process conditions. Adjust parameter value 'Upper
range value'.
200 CH2 pulse overflow Pulse output has insufficient pulse separation. Increase
Amount per pulse, or reduce Pulse width, or reduce Pulses
per amount.
201 CH3 loop current in lower
saturation
The process value is so low that the loop current reaches
the lower saturation limit and cannot decrease any further.
Check process conditions. Adjust parameter value 'Lower
range value'.
202 CH3 loop current in upper
saturation
The process value is so high that the loop current reaches
the upper saturation limit and cannot increase any further.
Check process conditions. Adjust parameter value 'Upper
range value'.
203 CH3 cable break Check current output cable connection. Passive operation:
check external power supply.
204 CH3 output frequency too
low
The process value is below the parameter 'Lower range
value'. The output frequency cannot decrease any further.
Check process conditions. Adjust parameter value 'Lower
range value'.
205 CH3 output frequency too
high
The process value is above the parameter 'Upper range
value'. The output frequency cannot increase any further.
Check process conditions. Adjust parameter value 'Upper
range value'.
Diagnostics and troubleshooting
10.2 Fault codes and corrective actions
SITRANS FC330
186 Operating Instructions, 01/2019, A5E44030648-AB