Current output SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Set fault current "Settings > Current out‐
put" parameter group
Select fault current
[10] (Page 120)
Lower fault current
[11] (Page 120)
Upper fault current
[12] (Page 121)
Commissioning the de‐
vice without display
(Page 13)
Set saturation limits "Settings > Current out‐
put" parameter group
Lower saturation limit
[13] (Page 121)/Upper
saturation limit [14]
(Page 122)
-
Digital-to-analog converter adjustment Menu command "De‐
vice > DAC trim"
- -
Loop test Menu command "De‐
vice > Loop test"
Loop test [31]
(Page 137)
-
Application SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Select pressure units "Settings > Units" pa‐
rameter group
Display of the pressure
units (Page 102)
-
Select the temperature unit for sensor and elec‐
tronics temperature
"Settings > Sensor
temperature units" pa‐
rameter group
Temperature units [17]
(Page 126)
-
Set additional measuring task (e.g. level, volume
flow, mass flow, volume, set customized charac‐
teristic curve)
"Settings > Select out‐
put > Application" pa‐
rameter group
Application [05]
(Page 106)
-
Set customized characteristic curve Menu command "De‐
vice > Customized
characteristic curve"
- -
Set scaling points "Settings > Current out‐
put > Scaling"
Lower scaling point
[18] (Page 126)/Upper
scaling point [19]
(Page 128)
-
Select unit of scaled value "Settings > Current out‐
put > Scaling > Units"
Units [16] (Page 123) -
Calibration SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Correct the zero point error Menu command "De‐
vice > Zero point ad‐
justment"
Zero point adjustment
[07] (Page 116)
Commissioning the de‐
vice without display
(Page 13)
Apply lower range value
Apply upper range value
Menu command "De‐
vice > Apply values"
Apply lower range val‐
ue parameter [08]
(Page 118)
Apply upper range val‐
ue parameter [09]
(Page 118)
Commissioning the de‐
vice without display
(Page 13)
Parameter assignment
9.1 Overview of parameters and functions
SITRANS P320/P420 (mA/HART)
98 Operating Instructions, 06/2018, A5E44852162-AA
To Next Page
Loading...
