Simulation SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Simulate fixed pressure value / simulate ramp Menu command "De‐
vice > Simulation >
Process values"
- -
Identification SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Read and configure identification data of your
device
"Identification" param‐
eter group
- -
Diagnostics SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Read diagnostic log Menu command "De‐
vice > Diagnostic log"
- -
Display of the diagnostics Diagnostics and troubleshooting (Page 181) -
Simulate diagnostics Menu command "De‐
vice > Simulation > Di‐
agnostics"
- -
Limit monitoring and event counter Menu command "De‐
vice > Limit monitoring
and event counter"
- -
Device maintenance, sensor maintenance, serv‐
ice, calibration
Menu command "Main‐
tenance"
- -
Display operating time Menu command "Diag‐
nostics > Device status
> HART status"
- -
Set peak values
Reset peak values
"Maintenance and di‐
agnostics > Peak val‐
ues" parameter group
Menu command "De‐
vice > Reset peak val‐
ues"
- -
Configure trend log
Show trend log
Menu command "De‐
vice > Trend log set‐
tings"
Menu command "Diag‐
nostics > Trend log"
- -
HART communication SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Configure HART address Menu command "De‐
vice > Assign address"
- -
Set the loop current value in multidrop mode "Settings > Current out‐
put > Loop current val‐
ue in multidrop mode"
- -
Parameter assignment
9.1 Overview of parameters and functions
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 99
To Next Page
Loading...
