Siemens WFx6 Series - Parameter Settings

ENSiemens Building Technologies A6V10816676_----_d 107
Parameter settings
To be able to activate programming mode, you have to be authorised for
programming by entering a PIN.
The default standard PIN is printed on the packaging product label.
Once the PIN has been accepted, further values can be programmed without
PIN input. Validity is lost if a level other than L3 or L4 is set.
Active parameter setting mode
• Keep pressing the < H > key until level or is reached.
• Keep pressing the < V > key until the parameter to be set appears on the
display.
• Press the key combination < H > + < V >.
• The display shows the window for password entry.
• Keeppressingthekeuntilthepositioncurrentlashinghasreached
the desired value.
• Press the < H > key to jump to the next position.
• Repeat steps 4 and 5 until the password has been entered completely.
• ConrmthepassordbthekecombinationH
• The display switches back to the value for which the parameter is to be set.
Parameter settings
To set parameters proceed as follows:
• Keeppressingthekeuntilthepositioncurrentlashinghasreached
the desired value.
• Press the < H > key to jump to the next position.
• Repeat steps 3 and 4 for all parameter positions.
• ConrmtheparametersettingbpressingkesHand