Operating Manual - English Triax QUATTRO
- 32 - Copyright Silca 2011
1
5.4.2.3
KEY CUTTING BY CODE
From the Search menu enter the indirect cutting code into the field and press ENTER.
Use the up-down arrow keys to scroll the list, select the required series and press ENTER.
F1
F2
F3
F1 for Manual adjustments.
F2 for User parameters.
F3 for Code entry.
(see Ch. 5.5)
F4
INDICATIONS on display and key-cutting PROCEDURE
The code in use is shown next to the window header : “SSN : 16 1 ”
At the end of the cutting operation press F3 to enter a new code.
For the full cutting flow see paragraph 5.4.2.1
To Next Page
Loading...
