Silca Triax Quattro - Cutter Calibration

Operating Manual - English Triax QUATTRO
- 52 - Copyright Silca 2011
1
5.10.2
CUTTER CALIBRATION
F1
F2
F3
F2 to enable the cutter calibration function.
F4
CUTTERS do not need an automatic calibration system.
N.B:
 the type of material and length can be edited where
applicable.
 it is good practice to set the type of material for the cutters
in your possession. In this way spindle speed will be
appropriate for the cutter required by the SSN in use.