Operating Manual - English Triax QUATTRO
- 72 - Copyright Silca 2011
1
6.3 ALARM MESSAGES
The temperature for the mother board has exceeded the
setting. Check the cooling fan (see TROUBLE SHOOTING
)
ALARM 1
TEMPERATURE ALARM
Mother board temperature
too high
Switch the machine off!
Indicates that the fuse has been cut out due to a short
circuit in an inlet or outlet (see TROUBLE SHOOTING)
ALARM 2
I/O POWER ALARM
Check F4 fuse
Indicates a short circuit on the port (IN/OUT) (see
TROUBLE SHOOTING)
ALARM 3
DIGITAL OUTLET
PROTECTION ALARM
Switch off the machine!
The message indicates faulty functioning of the axis
involved in the clearing procedure.
Clearing sensor or photocell not working.
Repeat the operation a number of times. If the problem
persists contact After-Sales.
ALARM 9
Axis movement not completed
during resetting phase!
This message appears when an application on the PC
tries to transfer data to the machine in the wrong
format.
Check whether there is a more recent version of the
program used by the PC.
ALARM 10
Data format received from PC is
not compatible with the machine
SW version.
See operating manual.
This happens when the wrong machine SW (i.e. not
specifically for the machine model) is downloaded.
ALARM 11
Machine hardware version is not
compatible with the installed
program.
To Next Page
Loading...
