Operating Manual - English Triax QUATTRO
- 68 - Copyright Silca 2011
1
6.2 ERROR MESSAGES
General message.
ERROR XX
INTERNAL ERROR
. . .
The message warns that the machine has reached a Z
axis measurement over the limit allowed.
If the problem persists contact After-Sales Service.
ERROR 1
Depth limit exceeded!
The machine automatic calibration procedure has read
adjustment values exceeding the tolerance established
by SILCA. Repeat the procedure and pay attention to all
the operations required. If the problem persists contact
After-Sales Service
.
ERROR 2
Tolerance limit exceeded during
calibration. Repeat the
operation.
See operating manual.
The spindle rotation release lever is out of line.
ERROR 3
Check tool installation and
stop lever position!
To Next Page
Loading...
