Simplex 2500 - How to Return a Point to AUTO

5. Press the cCLR> key. The display shows the following message.
I
**TROUBLE**
Press ACK to review.
ALARMS=0
SUPERVISORY=0 TROUBLE=1
I
HOW TO RETURN A POINT TO AUTO
The <AUTO> key press leaves a point in its current state (ON or OFF), but lowers its priority so that the system
program can control it. AUTO is the normal state for all control points. A trouble exists if any control point is taken
out of the AUTO state.
The point to be turned to AUTO must first be identified to the system. This is accomplished by selecting/entering the
required point on the alphanumeric display, and pressing the <AUTO> key. If the <AUTO> key is passcode
protected, perform the Log In Procedures.
To return a point to AUTO, perform the following procedures.
1. Ensure the point to be turned to AUTO is shown on the alphanumeric display. A typical point (2:SIG3) is
shown below.
I
4TH FLOOR - EAST WING - STROBES
VISUAL
OFF
I
2. Press the <AUTO> key. A typical display is shown below.
I
Press <ENTER> for AUTOmatic control
SIGNAL CIRCUIT:
2:SIG3
I
3. Press the <ENTER> key. A typical display is shown below.
I
4TH FLOOR - EAST WING - STROBES
VISUAL
OFF
I
4. Press the <TBL ACK> key.
5. Press the cCLR> key. The display shows the following message.
SYSTEM IS NORMAL
_'
9:27:40 MON 7 DEC 92
73
firealarmresources.com