l
This display shows the sensor’s highest value to date is 92. It also shows that the value of 92 represents
the following: 2% of the increase needed to cause an alarm and 0.0% equivalent percentage of smoke for
the 2% increase.
13. To exit the sensor’s viewing mode, press the cCLR> key twice.
ADDITIONAL KEYS
ENTER
The <ENTER> key is used to complete keypad entries. It is also used to select menu options and print list elements.
CLR (Clear)
The cCLR> key press is used to exit from a Main Menu Function option or abort an incomplete keypad entry. In most
cases, the current display will clear and will back up one level. Multiple cCLR> key presses will continue to back up
until the top level is reached. The top level will display the “SYSTEM IS NORMAL” followed by time and date,” or
the total number of abnormal conditions.
- (Hyphen)
The hyphen (-) portion of the <NET-> key is used to set the limits/boundaries for card address, point numbers, and
subpoint numbers during keypad entries.
DEL
(Delete)
The <DEL> key acts as a delete key during keypad inputs. It inserts a blank space in the current location and backs
up one position.
POINT SELECTION
Selecting Points Using Lists
Many of the functions performed from the operator interface panel display point specific data. Every system point is
part of the “Select A List of Points” list in the main menu. All points can be displayed sequentially by address order
using this list option. To facilitate the search for a particular point, lists may be selected by type groupings (monitors,
signals, auxiliary, input/output, pseudo points etc.). A list of points may be selected, then scrolled through by using
the <NEXT> and <PREVIOUS> keys. Selecting a list of points will expedite the search for a specific point with a
minimum of scrolling.
. The following lists are available for selection with the “Select a List of Points” option from the Main Function Menu:
l
All Monitor Zones (Not available for NDU)
l
All Signal Points (Not available for NDU)
l
All Auxiliary Relay Points (Not available for NDU)
l
All Auxiliary Feedback Points (Not available for NDU)
l
All Zones of 24-Point I/O Card (Not available for NDU)
l
All Digital Pseudo Points
l
All Analog Pseudo Points
l
All List Pseudo Points
l
All Points by Address List
l
All Network Points.
67
To Next Page
Loading...
