SKF P203 - Note on the Type Plate; Notes on CE Marking; Note on Pressure Equipment Directive; Note on UKCA Marking

11
1.11 Note on the type plate
The type plate provides important data such as the type
designation, order number, and sometimes regulatory
characteristics. To avoid loss of this data in case the type
plate becomes illegible, it should be entered in the
manual.
Table
2
Table for copying out the type plate
<Content>
Model:
P-No. :
S-No. :
Fig.
2
Type plate VDC with E1 and UL certification
1.12 Notes on CE marking
CE marking is effected following the
requirements of the applied directives
requiring a CE marking:
• 2014/30/EC Electromagnetic Compatibility
• 2011/65/EU Directive on the restriction of the use of
certain hazardous substances in electrical and
electronic equipment (RoHS II)
1.13 Note on Pressure Equipment
Directive
Due to its performance characteristics, the product does
not reach the limit values defined in Article 4, Paragraph
1, Subparagraph (a) (ii) and is excluded from the scope of
Pressure Equipment Directive 2014/68/EU in accordance
with Article 1, Paragraph 2 Subparagraph (f).
1.14 Note on UKCA marking
The UKCA conformity marking confirms the
product’s conformity with the applicable
legal provisions of Great Britain.
1.15 Note on UL mark
The UL Mark certifies that the product has
UL certification of compliance with U.S. and
Canadian safety regulations.
1.16 Note on ECE mark
The ECE test mark (E1) confirms that an ECE
type approval (components requiring
approval on motor vehicles) has been
granted for a product which bears this mark
on its type plate.
1.17 Notes on ADR certificate
Pumps with ADR certification are
marked with the sign shown here.
The use of the lubricant feed pumps described meets the
ADR requirements for the utilization of the ADR
connection materials specified in the type identification
code and for the correct performance of electrical
assembly outside of potentially explosive atmospheres in
Zones 0, 1 or 2 in vehicle types EX/II, EX/III, FL and AT.
Testing institute: TÜV-SÜD Auto Service GmbH
Component marking: TÜ.EGG.054-01
1.18 Note on EAC marking
The EAC conformity marking confirms the
product’s conformity with the applicable
legal provisions of the Eurasian customs
union.
1.19 Note on China RoHS mark
The China RoHS mark confirms that there is
no danger to persons or the environment
from the regulated substances contained
within for the intended period of use (year
number shown in the circle).
1.20 Emergency shutdown
This is done by a course of action to be defined by the
operator.