43
SKOPE TME/SKT ActiveCore
Replacement Procedures
Service Manual
Control Probe The control probe is cable tied to a bracket on the evaporator fan motor bracket.
Evaporator
Probe
The evaporator probe is located within the evaporator coil. It controls the refrigeration system
defrost initiation and termination.
Procedure 39: To replace the control probe
1. Remove the evaporator fan assembly (see page 38).
2. Detach the probe from the evaporator fan shroud bracket and trace the probe cable back to the unit
electrics box and unplug (see page 35).
3. Following the same path as the original probe, fit the new probe with cable ties as necessary.
Ensure the probe cable is securely plugged into the rear of the unit junction box, and that it is cable
tied to the evaporator fan shroud bracket, with the probe bent away from the fan bracket at a 45°
angle.
Procedure 40: To replace the evaporator probe
1. Isolate the fridge from the power supply and remove the refrigeration unit (see page 34).
2. Remove the unit cover (see page 37)
3. Remove the evaporator fan assembly (see page 38).
4. Remove both pieces of putty securing the pipes and cables on the evaporator tub perimeter.
5. Carefully lift the coil up and out of the evaporator tub. Take care of pipes and cables when lifting out.
6. Detach the probe from the side of the evaporator coil, and trace the probe cable back to the unit
electrics box and unplug (see page 35).
7. Following the same path as the original probe, run the new probe to the evaporator coil and secure
with cable ties. Locate the probe on the bottom hairpin bend, and ensure the probe is cabled tied
and insulated with cork tape as necessary, and that the probe cable is securely plugged into the
electrics box.
8. Reassemble the unit and test for correct operation.
To Next Page
Loading...
