38
Replacement Procedures
Service Manual
SKOPE TME/SKT ActiveCore
Evaporator
Fan
The evaporator fan assembly is made up of a fan motor and fan blade, both of which can be
replaced when necessary (see image below). The evaporator fan flexible cord has a white
plug.
If the fan stops for any reason, check all connections to ensure no plugs have come loose.
Refer to the label on the electrics box cover to identify the evaporator fan plug and socket in
the electrics box.
Procedure 30: To access the condenser fan assembly
1. Isolate the fridge from the power supply and remove the refrigeration unit (see page 34).
2. Remove the unit cover (see page 37).
3. Open the electrics box and unplug the condenser fan motor plug (see page 35).
4. Cut the cable ties holding the cables along the
base of the unit, and free up the condenser fan
motor cable.
5. Detach the high pressure switch flex from the
fan mounting bracket.
6. Remove the fan assembly (fan motor, fan blade, mounting brackets) from the unit by lifting the
shroud up and out.
Procedure 31: To replace the fan blade
1. Remove the condenser fan assembly (see above).
2. Remove the screw and washer from the centre of the fan blade, and lift the blade from the motor.
3. Replace new blade and fix with 12 mm flat washer and serrated head screw. Tighten the screw to
the fan motor manufacturer’s recommended torque setting (see page 37).
4. Reassemble unit and test.
Procedure 32: To replace the fan motor
1. Remove the condenser fan assembly and the fan blade (see above).
2. Unplug the fan flexible cord from the electrics box (see page 35).
3. Detach the fan motor from the fan mounting brackets by removing the four screws from the
mounting bracket.
4. Fit new motor and reattach fan blade with 12 mm flat washer and serrated head screw. Tighten the
screw to the fan motor manufacturer’s recommended torque setting (see page 37).
5. Reassemble unit, ensuring all cables are neatly cable tied away from the fan blade, and test for
correct operation.
To Next Page
Loading...
