Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer Userās Manual
V
Setting the holding and delaying time of "heating temperature".
Setting the thermostat heating temperature.
Setting the heating end temperature. When the heater is near this
temperature, the heating indicator is off, the buzzer alarms. At
this moment, the heater has been cooled and can be removed
from the furnace.
4.7.2 Selecting / Editing Heater mode
<1> SS413F fusion splicer factory default heater mode (heating parameter file):
No. 1, standard 60mm. If the user does not select other series number "heating
parameter files",No. 1 "splice parameter file" is used by default in the current
heat shrink sleeve operation.
<2> When the machine is delivered, in "Select heater parameter files"menu, in
numbers 1 to 9 splice parameter files, there are 9 operating parameters and
options for the user to edit and select;
<3> According to fusion splicing demand, the user can select and edit the
current"splice parameter files". For specific steps and requirements, please refer
to "3. 3.2edit/ select" of the manual.
To Next Page
Loading...