Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
User-friendly heating operation, SS413F series of fusion splicers are provided with
automatic heat control mode.
<1> Refer to "3.3.2 edit/ select" of the manual.in "Select heating parameter files"
window, "Manual" of "heat control" is set to "Auto" mode,realizing automatic
heater mode.
<2> When the operator puts the fiber heat shrink sleeve with fiber at the center of
the heater groove,after the transparent window comes down and the heater's
right press plate holds down effectively the fiber, the heater will work
automatically. The processes also include heating-up, thermostat and cooling
three-steps, finally the buzzer sounds.The heating indicator LED (red) is turned
off automatically.
<3> When the operator needs to stop the heating operation of the heater in process
of heating, the operator just presses keypadbutton .
● If the right press plate of the heater can not effectively hold down
the optical fiber (or fiber-optic breaks by pressing), automatic
heating is invalid.
To Next Page
Loading...