Warning!
1.The input voltage range of SS413F series fusion splicer is fixed. Do
not use the power voltage outside the range specified. Please use correct
AC and DC power supply.
2.Avoid the operation which may cause electrical shock, equipment
damage, or even fire disaster, personal injury or death. Please use a
dedicated three-wire grounded AC power line and AC / DC power
adapter.When the adapter input cable is connected to AC220V, 50 /
60HZ power supply, an effectively grounded three-holes socket must be
used.
3.Strictly prohibit to handle AC power cable, adapter and fusion splicer
with wet hand, or an electrical shock may occur.
4.When the fusion splicer encounters following faults, please unplug
immediately the power output cable of the adapter from the fusion
splicer power supply input port and shut down the fusion splicer,
otherwise, it will cause the fusion splicer unable to be repaired, even
cause bodily injury, death and fire.
＊
Smoke, smell, sound or abnormal heating up;
＊ Liquid, foreign matter go into the machine;
＊
Machine damage or falling down.
5. Do not use gas cleanser to clean the fusion splicer, otherwise the arc
of the machine electrode during arc will ignite combustibles, cause fires.
6.Do not operate the fusion splicer in flammable liquid or flammable
gas environment, Otherwise it will lead to serious consequences of fire,
explosion and so on.
7.Never touch the electrode of this model fusion splicer at work,
otherwise, the people will suffer a serious arc electric shock and burn.
Shut down the fusion splicer and disconnect the power supply before
replacing electrode.
8.Meet proper personal protection requirements in operation, in case the
fiber debris get into the eyes, mouth, skin or mouth, causing personal
injury.
To Next Page
Loading...