Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
Warning!
9.There are no parts required for maintenance in this model of fusion
splicer. Prohibit dismantling the fusion splicer and power module
(lithium batteries). Repair in any errors will cause the machine unable
repair even causing personal injury.
10.The power module (lithium battery) is strictly limited in this manual.
Wrong use will result in battery explosion, fires and personal injury.
Please strictly implement "Battery Precautions" in the manual, "Battery
Danger Warning" and other related requirements.
11.If the battery charging can not be completed or charge indicator can
not be converted within five hours, please stop charging immediately
and contact with our customer service center.
12.The fusion splicer battery is a consumable item. There is a safe
period of use. Extended use is strictly prohibited(Safe service life
means: The charge-discharge in normal use are less than 300 times).
NOTE!
1.Not to touch the fusion splicer heater and heat-shrink sleeve with
splicing process just completed, otherwise burn hazard will occur.
2.In routine maintenance, the ear syringe may be used for blowing off
the dust from the surface of the mirror and the objective lens of the
fusion splicer. The operator can also use special lens paper to clean. It is
recommended in principle not using alcohol to clean the mirror surface.
Please strictly implement the relevant requirement of the manual.
3.Do not store the fusion splicer at a high temperature or high humidity
environment.
To Next Page
Loading...