To Next Page

To Previous Page

SMA Solar Technology AG Commissioning

Technical Description SWebBox-TEN101232 27

6.7 Configuring the Sunny WebBox for Modem Operation

6.7.1 Notes on Configuring the Sunny WebBox with an Analog or

GSM Modem

The following sections describe how to connect and configure the Sunny WebBox to the telephone

network or GSM network with an Analog or GSM modem.

Configuration entails the following steps:

• Connect modem cable or GSM antenna (see page 27).

• Configure modem settings of the Sunny WebBox (see page 30).

• Determine the mounting/installation location in the GSM version (see page 30).

• Mount the GSM antenna with the bracket or extension set (see page 31).

6.7.2 Connect Modem Cable or GSM Antenna

Depending on the ordered version of your Sunny WebBox, carry out the steps in the corresponding

section:

• Sunny WebBox with analog modem, see section ”Connecting the Sunny WebBox to the

telephone network via modem cable” (page27).

• Sunny WebBox with GSM modem, see section ”Connecting the GSM antenna to a Sunny

WebBox” (page29).

Connecting the Sunny WebBox to the telephone network via modem cable

Recommendations for telephone network cabling

If the provided telephone cable is not long enough, observe the following instructions when

purchasing a new one, since the cable length and quality can adversely affect the signal

quality.

• Use a commercially available high quality cable. The telephone plug on either end

is an RJ11 Western plug.

• The maximum permitted cable length for analog telephones is 200 m.

SMA SUNNY WEBBOX Technical Description

Other manuals for SMA SUNNY WEBBOX