To Next Page

To Previous Page

User Guide

INTRODUCTION

The Primer – 600 marks the differences with any other equipment that exists

today. Its innovative design and cutting-edge technology permit tackling

resistance measurement tasks in a much more efficient manner, as it takes the

concept of manageability to extremes that have never been possible until now.

With Prime – 600, SMC opens the door to a new generation of test equipment,

based on the formula of innovation, and designed with and for the user, backed

by more than 30 years’ experience in the development of practical, affordable

and long-lasting solutions for its customers all over the world.

Until today, all the micro-ohmmeters on the market were limited to measuring the

resistance of a static object, presenting this on the screen as a value expressed

in Ohms. In contrast, the DRM function is incorporated into the Prime 600 from

factory. Until now this function, which draws a chart with the resistance values

measured on an object (typically the contact of a switch) at high speed and

precision in a short period of time, was only available in some switch analysis

devices.

It is extremely useful to assess the status of the main and arc contacts in sealed

switches (vacuum or SF6) with great speed and reliability, without having to

open them, with the subsequent cost saving.

You can carry out measurements one after another using the traditional method,

or get the Prime – 600 to automatically register the resistance values as you

apply the voltmeter tips at different points.

The Prime – 600 will show a confirmation message if it detects an error in its

connections, and will automatically demagnetise the load at the end of each test

for your safety. You can print out the results immediately or just save them on a

SMC Networks Prime-600 User Manual

Questions and Answers: