SMC Networks Prime-600 User Manual

User Guide
47
3. Orientate the transducer towards the device tested. The distance at which
it must be located will depend on the area to be measured. Follow the
diagram below, as reference.
4. Start the test by pressing .
Result:
If the test ends successfully, you can:
 Print out the result of the test by pressing .
 Save the result of the test by pressing .
The equipment will indicate the start of current injection with
two beeps and the end with one beep.

SMC Networks Prime-600 Specifications

General

Brand	SMC Networks
Model	Prime-600
Category	Measuring Instruments
Language	English