SMC Networks Prime-600 User Manual

User Guide
59
Manual equipment updating.
To carry out the updating, the Prime – 600 must be in programming mode.
1. If you press this button of the action bar to program, you can select the file
with the new firmware to be updated.
a. After pressing it, the file explorer opens. By default, it will open in
the folder “\AppData\Local\EuroSMC\Prime600” of the current
user.
2. Once selected, the window of the recording process appears.
3. After the process has ended correctly, the Prime – 600 will be rebooted.
The PrimeSync does not check if the version recorded is earlier
or later than the existing one in the equipment. It is totally
feasible to record a previous version to the one available on the
Prime – 600. This decision is the user’s responsibility.
Automatic equipment updating.
The PrimeSync application checks, when being executed, if there is a more
recent version of the Prime – 600 firmware in the EuroSMC software
repositories.
This process is carried out regardless of whether it is connected or not to a
Primer – 600 device, but the PC where the application is being executed, must
have an active connection to the Internet.
After the version check, if there is a more recent version, this is downloaded.
The entire process occurs without any notification to the user.

SMC Networks Prime-600 Specifications

General

Brand	SMC Networks
Model	Prime-600
Category	Measuring Instruments
Language	English