User Guide
29
2. Print out the test result.
“Dynamic” work mode (Dynamic resistance).
We will select this work mode when we need to study, over time, the behaviour
of the contact resistance during the opening of a switch.
Setup:
1. Connect the high current cables to the current taps of the Prime - 600.
2. Connect the measurement cables to the voltage measurement
connections of the Prime - 600.
3. Turn on the equipment.
Indicates work mode, date and
time, and description, entered by
the user, for the test
Header
Indicates equipment serial no. (S/N)
and firmware version (V.)
To Next Page
Loading...
