Available Supplies
MicroDisk
Use Smith Corona MicroDisks with your Personal Word Processor which have been qualified
specifically for your product.
Dust Cover
Protect your
PWP
System from dust and foreign particles by covering
it
with our custom fitted
dust cover.
Tilt Swivel Base
Add mobility to your monitor with the addition of our tilt swivel base. The base allows the
monitor to be adjusted to your viewing position and eliminate any glare.
Important:
When printing repetitive letters or long documents, we recommend the use of Smith Corona
multi-strike carbon film ribbon for increased character yield.
Safe Operating Recommendations
To avoid unnecessary injury
to
the operator or damage to the unit, please review the following
recommendations.
1.
Be sure that the correct electrical current
is
used. (Standard United States and Canadian
current is
110
to
120
volt,
60
HZ,
alternating current.) Other countries may use different
currents. If in doubt, check the electric rating label affixed to the unit. The wrong kind of
current could cause an electrical short circuit and possible over-heating or shocks.
2.
Do not, for any reason, cut or remove the grounding prong from the power cord.
Be
sure
it
is
plugged into a properly installed grounding type receptacle. The three-prong
grounding plug
is
provided for your protection against shock hazards. Removing the
prong or using an improper receptable eliminates that protection.
3.
Never insert metal objects such as screwdrivers, paper
clips,
nail files, etc. inside the unit.
4.
If the unit
is
accidentally dropped, have it checked by a qualified service technician
before using it again.
5.
Do not remove the housing from the
unit.
This should be done only by a qualified service
technician.
6. Always have the unit serviced by a qualified service technician.
7.
Avoid placing the unit near excessively warm and humid locations.
8. Do not place the monitor where sunlight or bright light will fall directly on the screen.
9. Before attempting to clean any part of your unit make sure it
is
turned off and
unplugged.
10.
In order to prevent overheating, ensure that the ventilation openings in the MONITOR
are not covered. The MONITOR should not be placed near a source of heat.
WARNING:
To
reduce risk of fire or electric shock, DO
NOT
expose unit to rain or moisture.
58
To Next Page
Loading...