102
Scope and Multimeter Operations Navigation
Trace Details
The Trace Details section displayed at the base of the screen can be used to quickly adjust
settings for capturing the trace. The Trace details are accessed using either the Data icon on the
upper toolbar or the Touch and Grow icon on the Playback toolbar. Both icons function the same
and cycle the Trace Details selection through three states:
• Displayed—trace settings are displayed in this mode.
• Expanded—trace settings are displayed in a larger format in this mode.
• Off—trace settings are not displayed in this mode.
Adjustments are made by selecting the item to be changed on the touch screen. A dash (–)
indicates a function that is not selected, and an icon indicates an active function (Figure 8-15).
1— Peak Detect on
2— Filter on
3— Inverted trace
4— Coupling AC on
5— Sweep setting
6— Trigger setup
7— Trigger set on the rising slope
Figure 8-15 Sample data detail display
To Next Page
Loading...
Need help?
General
