13
v1.01
M215SC User Manual Introduction
Introduction
In a typical telephony system, the IP DECT base station is connected to the local area network (LAN) which, in
turn, is connected to a PBX or an IP Service Provider. The base station converts IP protocol to DECT protocol and
transmits phone calls to and from the DECT handsets.
To be able to use the M-series DECT phones, the base station must be connected to your LAN and the handset(s)
must be registered at the base station. This manual covers the manual configuration of one base station and
one handset.
The base station follows most Snom configuration and management schemes. It is recommended to have a
local HTTP/HTTPS server for firmware updates, central configuration management, and hosting firmware files
for base stations, handsets, and repeaters. Handsets are updated over the air by the base station.
Normally the initialization of the base station is completely automatic, using DHCP. If the base station cannot
discover a DHCP server in the subnet, you can set it up manually via its web interface. As a minimum you will
need to enter the IP address, netmask, IP gateway, and DNS server. Your VoIP service provider or your network
may require more data; please ask your provider or your network's administrator for the requisite input.
To Next Page
Loading...
